Chapter 8
| Authentication Commands
802.1X Port Authentication
– 256 –
General Commands
dot1x default This command sets all configurable dot1x authenticator global and port settings to
their default values.
Command Mode
Global Configuration
Command Usage
This command resets the following commands to their default settings:
◆ dot1x system-auth-control
◆ dot1x eapol-pass-through
◆ dot1x port-control
◆ dot1x port-control multi-host max-count
◆ dot1x operation-mode
◆ dot1x max-req
◆ dot1x timeout quiet-period
◆ dot1x timeout tx-period
◆ dot1x timeout re-authperiod
◆ dot1x timeout sup-timeout
◆ dot1x re-authentication
◆ dot1x intrusion-action
dot1x operation-mode Allows single or multiple hosts on an dot1x port IC
dot1x port-control Sets dot1x mode for a port interface IC
dot1x re-authentication Enables re-authentication for all ports IC
dot1x timeout quiet-period Sets the time that a switch port waits after the Max Request
Count has been exceeded before attempting to acquire a
new client
IC
dot1x timeout re-authperiod Sets the time period after which a connected client must
be re-authenticated
IC
dot1x timeout supp-timeout Sets the interval for a supplicant to respond IC
dot1x timeout tx-period Sets the time period during an authentication session that
the switch waits before re-transmitting an EAP packet
IC
dot1x re-authenticate Forces re-authentication on specific ports PE
Information Display Commands
show dot1x Shows all dot1x related information PE
Table 48: 802.1X Port Authentication Commands (Continued)
Command Function Mode
To Next Page
Loading...
