Edge-Core ECS4120-28F

Chapter 25 | LLDP Commands
– 756 –
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv pvid
Console(config-if)#
lldp dot1-tlv
vlan-name
This command configures an LLDP-enabled port to advertise its VLAN name. Use
the no form to disable this feature.
Syntax
[no] lldp dot1-tlv vlan-name
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the name of all VLANs to which this interface has been
assigned. See switchport allowed vlan and protocol-vlan protocol-group
(Configuring Interfaces).
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv vlan-name
Console(config-if)#
lldp dot3-tlv link-agg This command configures an LLDP-enabled port to advertise link aggregation
capabilities. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv link-agg
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises link aggregation capabilities, aggregation status of the link,
and the 802.3 aggregated port identifier if this interface is currently a link
aggregation member.