Chapter 4
| System Management Commands
SMTP Alerts
– 153 –
Example
This example will send email alerts for system errors from level 3 through 0.
Console(config)#logging sendmail level 3
Console(config)#
logging sendmail
destination-email
This command specifies the email recipients of alert messages. Use the no form to
remove a recipient.
Syntax
[no] logging sendmail destination-email email-address
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to five recipients for alert messages. However, you must enter a
separate command to specify each recipient.
Example
Console(config)#logging sendmail destination-email ted@this-company.com
Console(config)#
logging sendmail
source-email
This command sets the email address used for the “From” field in alert messages.
Use the no form to restore the default value.
Syntax
logging sendmail source-email email-address
no logging sendmail source-email
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Default Setting
None
Command Mode
Global Configuration
To Next Page
Loading...
Need help?
General