Chapter 4
| System Management Commands
System Status
– 112 –
capabilities 1000full
!
interface ethernet 1/1
interface vlan 1
ipv6 enable
ipv6 address 2001:db8:2222:7272::/64
ipv6 address fe80::260:3eff:fe11:6700 link-local
!
ipv6 default-gateway 2001:db8:2222:7272::254
.
.
.
!
line console
!
line vty
!
end
!
Console#
Related Commands
show startup-config (112)
show startup-config This command displays the configuration file stored in non-volatile memory that is
used to start up the system.
Command Mode
Privileged Exec
Command Usage
◆ Use this command in conjunction with the show running-config command to
compare the information in running memory to the information stored in non-
volatile memory.
◆ This command displays settings for key command modes. Each mode group is
separated by “!” symbols, and includes the configuration mode command, and
corresponding commands. This command displays the following information:
■
MAC address for the switch
■
SNMP community strings
■
Users (names, access levels, and encrypted passwords)
■
VLAN database (VLAN ID, name and state)
■
VLAN configuration settings for each interface
■
Multiple spanning tree instances (name and interfaces)
■
IP address configured for management VLAN
■
Spanning tree settings
■
Interface settings
■
Any configured settings for the console port and Telnet
◆ For security reasons, user passwords are only displayed in encrypted format.
To Next Page
Loading...
Need help?
General