EasyManuals Logo

Edge-Core ECS4120-28F Reference Guide

Edge-Core ECS4120-28F
938 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #733 background imageLoading...
Page #733 background image
Chapter 24
| Multicast Filtering Commands
MVR for IPv6
– 733 –
Default Setting
No receiver port is a member of any configured multicast group.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Multicast groups can be statically assigned to a receiver port using this
command. The assigned address must fall within the range set by the mvr6
associated-profile command.
All IPv6 addresses must be according to RFC 2373 “IPv6 Addressing
Architecture,” using 8 colon-separated 16-bit hexadecimal values. One double
colon may be used in the address to indicate the appropriate number of zeros
required to fill the undefined fields. (Note that the IP address ff02::X is reserved.)
The MVR6 VLAN cannot be specified as the receiver VLAN for static bindings.
Example
The following statically assigns a multicast group to a receiver port:
Console(config)#vlan database
Console#show lldp info remote-device detail ethernet 1/1
LLDP Remote Devices Information Detail
----------------------------------------------------------------------------
Index : 1
Chassis Type : MAC Address
Chassis ID : 00-E0-0C-10-90-00
Port ID Type : MAC Address
Port ID : 00-E0-0C-10-90-04
Time To Live : 120 seconds
Console#show lldp info remote-device detail ethernet 1/28
LLDP Remote Devices Information Detail
Console#show lldp info remote-device detail ethernet 1/28
LLDP Remote Devices Information Detail
Console#con
Console(config)#vlan database
Console(config-vlan)#vlan 2 media ethernet
Console(config-vlan)#exit
Console(config)#mvr6 profile test ff01::1 ff01::8
Console(config)#mvr6 domain 1
Console(config)#mvr6 domain 1 vlan 2
Console(config)#mvr6 domain 1 associated-profile test
Console(config)#interface ethernet 1/1
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#mvr6 domain 1 vlan 1 group ff01::8
Console(config-if)#exit
Console(config)#interface ethernet 1/1
Console(config-if)#mvr6 domain 1 type receiver
Console(config-if)#mvr6 domain 1 vlan 1 group ff01::8
Console(config-if)#end
Console#show mvr6 domain 1 members
MVR6 Domain : 1
MVR6 Forwarding Entry Count :0
Console#show mvr6 domain 1 members ff00::1
MVR6 Domain : 1

Table of Contents

Other manuals for Edge-Core ECS4120-28F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS4120-28F and is the answer not in the manual?

Edge-Core ECS4120-28F Specifications

General IconGeneral
BrandEdge-Core
ModelECS4120-28F
CategorySwitch
LanguageEnglish

Related product manuals