Chapter 25
| LLDP Commands
– 763 –
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp med-tlv med-cap
Console(config-if)#
lldp med-tlv
network-policy
This command configures an LLDP-MED-enabled port to advertise its network
policy configuration. Use the no form to disable this feature.
Syntax
[no] lldp med-tlv network-policy
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises network policy configuration information, aiding in the
discovery and diagnosis of VLAN configuration mismatches on a port. Improper
network policy configurations frequently result in voice quality degradation or
complete service disruption.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp med-tlv network-policy
Console(config-if)#
lldp notification This command enables the transmission of SNMP trap notifications about LLDP
changes in remote neighbors. Use the no form to disable LLDP notifications.
Syntax
[no] lldp notification
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
â—† This option sends out SNMP trap notifications to designated target stations at
the interval specified by the lldp notification-interval command. Trap
To Next Page
Loading...
Need help?
General