Chapter 13
| Power over Ethernet Commands
– 443 –
power inline
time-range
This command binds a time-range to a port during which PoE is supplied to the
attached device. Use the no form to remove this binding.
Syntax
power inline time-range time-range-name
no power inline time-range
time-range-name - Name of the time range. (Range: 1-32 characters)
Default Setting
None
Command Mode
Interface Configuration (Ethernet ports 1-24)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#power inline time-range rd
Console(config-if)#
Related Commands
time-range (168)
show power inline
status
This command displays the current power status for all ports or for specific ports.
Syntax
show power inline status [interface]
interface
ethernet
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-24)
Command Mode
Privileged Exec
Example
Console#show power inline status
Unit: 1
Compatible Mode : Disabled
Time Max Used
Interface Admin Range Oper Power Power Priority
--------- -------- -------- ---- -------- -------- --------
Eth 1/ 1 Enabled -- Off 30000 mW 0 mW Low
Eth 1/ 2 Enabled -- Off 30000 mW 0 mW Low
Eth 1/ 3 Enabled -- Off 30000 mW 0 mW Low
Eth 1/ 4 Enabled -- Off 30000 mW 0 mW Low
To Next Page
Loading...
Need help?
General