Chapter 24
| Multicast Filtering Commands
Static Multicast Routing
– 663 –
Static Multicast Routing
This section describes commands used to configure static multicast routing on
the switch.
ip igmp snooping vlan
mrouter
This command statically configures a (Layer 2) multicast router port on the
specified VLAN. Use the no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4094)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-26)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
â—† Depending on your network connections, IGMP snooping may not always be
able to locate the IGMP querier. Therefore, if the IGMP querier is a known
multicast router or switch connected over the network to an interface (port or
V2 Warning Count The number of times the query version received (Version 2) does not
match the version configured for this interface.
V3 Warning Count The number of times the query version received (Version 3) does not
match the version configured for this interface.
Table 132: show ip igmp snooping statistics vlan query - display description
Field Description
Table 133: Static Multicast Interface Commands
Command Function Mode
ip igmp snooping vlan
mrouter
Adds a multicast router port GC
show ip igmp snooping
mrouter
Shows multicast router ports PE
To Next Page
Loading...
Need help?
General