Chapter 11
| Interface Commands
Interface Configuration
– 407 –
show interfaces status This command displays the status for an interface.
Syntax
show interfaces status [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-26)
vlan vlan-id (Range: 1-4094)
Default Setting
Shows the status for all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
Console#show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Port Type : 1000BASE-T
MAC Address : 00-00-0C-00-00-FE
Configuration:
Name :
Port Admin : Up
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full, 1000full
Broadcast Storm : Enabled
Broadcast Storm Limit : 500 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 262143 packets/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 262143 packets/second
Flow Control : Disabled
VLAN Trunking : Disabled
LACP : Disabled
MAC Learning : Enabled
Link-up-down Trap : Enabled
Media Type : None
MTU : 1518
Current Status:
Link Status : Up
Port Operation Status : Up
Operation Speed-duplex : 100full
Up Time : 0w 0d 2h 14m 3s (8043 seconds)
Flow Control Type : None
Max Frame Size : 1518 bytes (1522 bytes for tagged frames)
To Next Page
Loading...
Need help?
General