Chapter 4
| System Management Commands
Banner Information
– 102 –
banner configure
ip-lan
This command is used to configure the device IP address and subnet mask
information displayed in the banner. Use the no form to restore the default setting.
Syntax
banner configure ip-lan ip-mask
no banner configure ip-lan
ip-mask - The IP address and subnet mask of the device.
(Maximum length: 32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
Input strings cannot contain spaces. The banner configure ip-lan command
interprets spaces as data input boundaries. The use of underscores ( _ ) or other
unobtrusive non-letter characters is suggested for situations where white space is
necessary for clarity.
Example
Console(config)#banner configure ip-lan 192.168.1.1/255.255.255.0
Console(config)#
banner configure
lp-number
This command is used to configure the LP number information displayed in the
banner. Use the no form to restore the default setting.
Syntax
banner configure lp-number lp-num
no banner configure lp-number
lp-num - The LP number. (Maximum length: 32 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
Input strings cannot contain spaces. The banner configure lp-number command
interprets spaces as data input boundaries. The use of underscores ( _ ) or other
unobtrusive non-letter characters is suggested for situations where white space is
necessary for clarity.
To Next Page
Loading...
Need help?
General