Chapter 24
| Multicast Filtering Commands
MVR for IPv4
– 706 –
source ports on the switch and to all receiver ports that have elected to receive
data on that multicast address.
â—† When the mvr source-port-mode dynamic command is used, the switch only
forwards multicast streams which the source port has dynamically joined. In
other words, both the receiver port and source port must subscribe to a
multicast group before a multicast stream is forwarded to any attached client.
Note that the requested streams are still restricted to the address range which
has been specified in a profile and bound to a domain.
Example
Console(config)#mvr source-port-mode dynamic
Console(config)#
mvr upstream-
source-ip
This command configures the source IP address assigned to all MVR control packets
sent upstream on all domains or on a specified domain. Use the no form to restore
the default setting.
Syntax
mvr [domain domain-id] upstream-source-ip source-ip-address
no mvr [domain domain-id] upstream-source-ip
domain-id - An independent multicast domain. (Range: 1-5)
source-ip-address – The source IPv4 address assigned to all MVR control
packets sent upstream.
Default Setting
All MVR reports sent upstream use a null source IP address
Command Mode
Global Configuration
Example
Console(config)#mvr domain 1 upstream-source-ip 192.168.0.3
Console(config)#
To Next Page
Loading...
Need help?
General