To Next Page

To Previous Page

Chapter 19

| Spanning Tree Commands

– 506 –

name This command configures the name for the multiple spanning tree region in which

this switch is located. Use the no form to clear the name.

Syntax

name name

name - Name of the spanning tree.

Default Setting

Switch’s MAC address

Command Mode

MST Configuration

Command Usage

The MST region name and revision number (page 506) are used to designate a

unique MST region. A bridge (i.e., spanning-tree compliant device such as this

switch) can only belong to one MST region. And all bridges in the same region must

be configured with the same MST instances.

Example

Console(config-mstp)#name R&D

Console(config-mstp)#

Related Commands

revision (506)

revision This command configures the revision number for this multiple spanning tree

configuration of this switch. Use the no form to restore the default.

Syntax

revision number

number - Revision number of the spanning tree. (Range: 0-65535)