Chapter 8
| Authentication Commands
Management IP Filter
– 269 –
Example
This example restricts management access to the indicated addresses.
Console(config)#management all-client 192.168.1.19
Console(config)#management all-client 192.168.1.25 192.168.1.30
Console#
show management This command displays the client IP addresses that are allowed management
access to the switch through various protocols.
Syntax
show management {all-client | http-client | snmp-client | telnet-client}
all-client - Displays IP addresses for all groups.
http-client - Displays IP addresses for the web group.
snmp-client - Displays IP addresses for the SNMP group.
telnet-client - Displays IP addresses for the Telnet group.
Command Mode
Privileged Exec
Example
Console#show management all-client
Management Ip Filter
HTTP-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
SNMP-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
TELNET-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
Console#
To Next Page
Loading...
Need help?
General