– 639 –
24 Multicast Filtering Commands
This switch uses IGMP (Internet Group Management Protocol) to check for any
attached hosts that want to receive a specific multicast service. It identifies the
ports containing hosts requesting a service and sends data out to those ports only.
It then propagates the service request up to any neighboring multicast switch/
router to ensure that it will continue to receive the multicast service.
IGMP Snooping
This section describes commands used to configure IGMP snooping on the switch.
Table 128: Multicast Filtering Commands
Command Group Function
IGMP Snooping Configures multicast groups via IGMP snooping or static assignment,
sets the IGMP version, enables proxy reporting, displays current
snooping settings, and displays the multicast service and group
members
Static Multicast Routing Configures static multicast router ports which forward all inbound
multicast traffic to the attached VLANs
IGMP Filtering and
Throttling
Configures IGMP filtering and throttling
MLD Snooping Configures multicast snooping for IPv6
MLD Filtering and
Throttling
Configures MLD filtering and throttling for IPv6.
MVR for IPv4 Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving security
and data isolation for normal traffic
MVR for IPv6 Configures a single network-wide multicast VLAN shared by hosts
residing in other standard or private VLAN groups, preserving security
and data isolation for normal traffic
Table 129: IGMP Snooping Commands
Command Function Mode
ip igmp snooping Enables IGMP snooping GC
ip igmp snooping priority Assigns a priority to all multicast traffic GC
ip igmp snooping
proxy-reporting
Enables IGMP Snooping with Proxy Reporting GC
ip igmp snooping querier Allows this device to act as the querier for IGMP snooping GC
To Next Page
Loading...
Need help?
General