Chapter 21
| VLAN Commands
Editing VLAN Groups
– 562 –
Editing VLAN Groups
vlan database This command enters VLAN database mode. All commands in this mode will take
effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆ Use the VLAN database command mode to add, change, and delete VLANs.
After finishing configuration changes, you can display the VLAN settings by
entering the show vlan command.
◆ Use the interface vlan command mode to define the port membership mode
and add or remove ports from a VLAN. The results of these commands are
written to the running-configuration file, and you can display this file by
entering the show running-config command.
Example
Console(config)#vlan database
Console(config-vlan)#
Related Commands
show vlan (571)
Table 108: Commands for Editing VLAN Groups
Command Function Mode
vlan database Enters VLAN database mode to add, change, and delete
VLANs
GC
vlan Configures a VLAN, including VID, name and state VC
To Next Page
Loading...
