Chapter 3
| General Commands
– 92 –
Command Mode
Privileged Exec
Example
Console#configure
Console(config)#
Related Commands
end (93)
disable This command returns to Normal Exec mode from privileged mode. In normal
access mode, you can only display basic information on the switch's configuration
or Ethernet statistics. To gain access to all commands, you must use the privileged
mode. See “Understanding Command Modes” on page 78.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
The “>” character is appended to the end of the prompt to indicate that the system
is in normal access mode.
Example
Console#disable
Console>
Related Commands
enable (89)
reload (Privileged Exec) This command restarts the system.
Note:
When the system is restarted, it will always run the Power-On Self-Test. It will
also retain all configuration information stored in non-volatile memory by the copy
running-config startup-config command.
Default Setting
None
Command Mode
Privileged Exec
To Next Page
Loading...
Need help?
General