Chapter 11
| Interface Commands
Interface Configuration
– 404 –
show interfaces
history
This command displays statistical history for the specified interfaces.
show interfaces history [interface [name [current |
previous index count] [input | output]]]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-26)
name - Name of sample as defined in the history command.
(Range: 1-32 characters)
current - Statistics recorded in current interval.
previous - Statistics recorded in previous intervals.
index - An index into the buckets containing previous samples.
(Range: 1-96)
count - The number of historical samples to display. (Range: 1-96)
input - Ingress traffic.
output - Egress traffic.
Default Setting
Shows historical statistics for all interfaces, intervals, ingress traffic, and egress
traffic.
Command Mode
Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Input utilization The input utilization rate for this interface.
Octets Output in kbits per
second
Number of octets leaving this interface in kbits per second.
Packets output per second Number of packets leaving this interface in packets per second.
Output utilization The output utilization rate for this interface.
Table 75: show interfaces counters - display description (Continued)
Parameter Description
To Next Page
Loading...
Need help?
General