Edwards nEXT85 User Manual

Command ! S
8 7 2
sp
0
cr
The reply will be as follows:
Reply * S
8 7 2
sp
r
cr
To check whether electronic braking is enable or disable, send the following query:
Command ? S
8 7 2
cr
The reply will be as follows (where d=0 means disabled and d=1 means enabled):
Reply
= S
8 7 2
sp
d
cr
Factory sengs
The nEXT85 pump can be re-congured to its original factory sengs with one serial
command.
To reset the motor controller to factory sengs, send the following command:
Command
! S
8 6 7
sp
1
cr
The reply will be in the following format:
Reply
* S
8 6 7
sp
r
cr
The factory sengs are restored in the memory within the nEXT85 pump. A Power cycle may
be required if either valve type seng was previously congured to a non-default seng.
Assigning a mul-drop address
Each individual pump must be programmed with its own
mul-drop address via a point-to-
point connecon before introducon into a mul-drop network.
When the nEXT85 pump is shipped, mul-drop mode is disabled by default.
Send the following command to assign a mul-drop address (where the 'd' characters
represent the address):
Command
! S
8 5 0
sp
d d
cr
Note:
The address can be any decimal number from 1 to 98. The address number 0 is used to
disable mul-drop mode. The address number 99 is reserved as a wild card and is used in the
query set up detailed later.
The reply will be in the following format:
Reply
* S
8 5 0
sp
r
cr
The mul-drop address is stored within the nEXT85 pump.
A query can be sent to the pump to nd out if it has a mul-drop address. Send the following
command:
B8G0-00-880A -
Conguraon
Page 42

Edwards nEXT85 Specifications

General

Brand	Edwards
Model	nEXT85
Category	Water Pump
Language	English