To Next Page

To Previous Page

Install the nEXT85

Unpack and inspect

The pump is supplied in a cardboard box and does not require liing equipment.

WARNING:

Appropriate care should be taken when liing and moving the pump to avoid injury. The

user must adhere to manual handling guidelines.

WARNING:

The motor controller cable should not be used as a liing device. Do not aempt to li or

support the pump using the cable.

CAUTION:

Local legislaon concerning the impact of the pump on the environment must be followed

when installing and removing the pump.

1. Take care when unpacking the pump to avoid excessive shocks which could damage

the bearings and reduce the life of the pump. The pump is supplied with the inlets and

outlet sealed to prevent entry of dust and vapour. Do not remove these seals unl

ready to install the pump on the vacuum system.

2. Open the cardboard box from the top. Once the box lid is open, remove the upper

pieces of foam and cut open the bag.

3. If the pump is damaged, nofy the supplier and the carrier in wring within three

days; state the item number of the pump together with the order number and the

supplier's invoice number. Retain all packing materials for inspecon. Do not use the

pump if it is damaged.

4. Check that the package contains the items listed in Table 1 on page 19. If any of

these items are missing, nofy the supplier in wring within three days.

5. If the pump is not to be used immediately, store in suitable condions as described in

Storage on page 63.

6. It is advised to retain all packing materials for use, should you return the pump for

service.

Table 1 Checklist of items

Quanty Descripon Check

1 nEXT85 Turbomolecular Vacuum Pump

❏

1 Integral mesh centring ring O-ring seal (ISO variants

only. Screen will be ed to CF pumps.)

❏

B8G0-00-880A - Install the nEXT85

Page 19

Edwards nEXT85 User Manual

Other manuals for Edwards nEXT85