Eldes ESIM264 - Page 111

MANUAL ELDES ESIM264 V2.0 111
8.6.2 Installation
1. Open EWS1 enclosure.
Insert a thin at-shaped screwdriver or any tool alike into the gap located on the back of the enclosure (see Fig. No. 44).
Push the screwdriver down to the right carefully in order to detach the enclosure parts from each other (see Fig. No. 45)
2. Once the enclosure is opened, remove the plastic tab inserted between one of the battery terminals and battery slot contact (see
Fig. No. 46).
Fig. No. 44
Fig. No. 45
Fig. No. 46