Eldes ESIM264 - Page 41

MANUAL ELDES ESIM264 V2.0 41
SMS
N/A
EKB2
Menu path:
OK → CONFIGURATION → ZONES → WIRED ZONES → [ZONE 1... 12] → STAY → DISABLE
OK → CONFIGURATION → ZONES → WIRELESS ZONES
→ RF ZONE [1... 16]→ STAY → DISABLE
OK → CONFIGURATION → ZONES → KEYBOARD ZONES
→ [1ST... 4TH] KEYBOARD ZONE → STAY → DISABLE
OK → CONFIGURATION → ZONES →
EPGM ZONES → EPGM ZONE [1... 16] → STAY → DISABLE
EKB3
Enter parameter 56, zone number & parameter status value:
[56xx0#]
Value: xx – zone number, range – [01... 44]
SMS
N/A
EKB2
Menu path:
OK → CONFIGURATION → ZONES → WIRED ZONES → [ZONE 1... 12] → FORCE → ENABLE
OK → CONFIGURATION → ZONES → WIRELESS ZONES →
RF ZONE [1... 16]→ FORCE → ENABLE
OK → CONFIGURATION → ZONES → KEYBOARD ZONES
→ [1ST... 4TH] KEYBOARD ZONE → FORCE → ENABLE
OK → CONFIGURATION → ZONES → EPGM ZONES →
EPGM ZONE [1... 16] → FORCE → ENABLE
EKB3
Enter parameter 82, zone number & parameter status value:
[82xx1#]
Value: xx – zone number, range – [01... 44]
This command disables Stay mode for a specied zone.
Force mode allows the user to arm the alarm system even if the zone operating under Force
mode is violated. This zone begins operating according to its‘ type and does not ignore vio-
lation after the system is armed and the zone is restored. By default, this feature is disabled
for all zones.
Disable Stay Mode
for a Specied Zone
Enable Force Mode
for a Specied Zone