Eldes ESIM264 - Page 47

MANUAL ELDES ESIM264 V2.0 47
SMS
N/A
EKB2
N/A
EKB3
Enter parameter 49, rule number & parameter status value:
[49xx1#]
Value: xx – rule number, range – [01... 16]
SMS
N/A
EKB2
N/A
EKB3
Enter parameter 49, rule number & parameter status value:
[49xx0#]
Value: xx – rule number, range – [01... 16]
SMS
N/A
EKB2
Menu path:
OK → CONFIGURATION → USING EPGM8 → ENABLE
EKB3
Enter parameter 33 & parameter status value:
[3312#]
The system supports up to 16 rules allowing to set automatic PGM output control by assi-
gning it to a particular system event: arm/disarm, system alarm/restore, temperature chan-
ges, by scheduled date & time, particular zone alarm/restore in particular partition or in both
partitions. By default all rules are disabled.
This command disables particular rule.
The number of wired PGM outputs can be expanded to 12 by connecting EPGM8 - 8 PGM out-
put expan sion module. By default, EPGM8 module mode is disabled.
Enable Automatic
PGM Output Control
Disable Automatic
PGM Output Control
Enable EPGM8
Module Mode
NOTE: Automatic PGM output control can be fully congured using ELDES Conguration Tool software.