Eldes ESIM264 - Page 50

50
SMS
N/A
EKB2
Menu path:
OK → CONFIGURATION → PRIMARY SET → SIREN SET → RF LOSS ALARM → ENABLE
EKB3
Enter parameter 76 & parameter status value:
[761#]
SMS
N/A
EKB2
Menu path:
OK → CONFIGURATION → PRIMARY SET → SIREN SET → RF LOSS ALARM → DISABLE
EKB3
Enter parameter 76 & parameter status value:
[760#]
When the system is armed, the siren is activated in case of wireless connection loss between
the alarm system and any wireless device. By default this feature is disabled.
This command disables Siren ON if RF Signal is Lost feature.
Enable Siren ON if
RF Signal is Lost
Disable Siren ON if
RF Signal is Lost
NOTE: The siren is always activated in case of alarm (depending on zone type), despite the status of Siren ON if RF Signal is Lost
feature.