Endress+Hauser Proline Promass 83 - Resource Block Parameters

2 Resource Block Device Functions Proline Promass 83 FOUNDATION Fieldbus
108 Endress+Hauser
2.5 Resource Block parameters
The following table shows the Endress+Hauser-specific parameters of the Resource Block.
!
Note!
FOUNDATION Fieldbus parameters are described in the Operating Instructions "FOUNDATION
Fieldbus Overview" (BA013S) (available at: → www.endress.com → download).
Resource Block
Parameter
Write access
with operating
mode
(MODE_BLK)
Description
Sensor - Serial Number read only Use this function to view the sensor serial number.
Amp. - HW Rev.Number read only Use this parameter to view the hardware revision number of the
amplifier.
Amp. - HW Identification read only Use this parameter to view the hardware ID number of the amplifier.
Amp. - SW Rev.Number read only Use this function to view the software revision number of the
amplifier.
Amp. - SW Identification read only Use this function to view the software ID number of the amplifier.
Amp. - Prod.-Number read only Use this parameter to view the production number of the amplifier.
Amp. - SW-Rev.No.
T-DAT
read only Use this parameter to view the software revision number of the
software used to create the content of the T-DAT.
Amp. - Language Group read only Use this function to view the language group.
I/O - Type read only Use this function to view the I/O module type.
I/O - HW Rev.Number read only Use this function to view the hardware revision number of the
I/O module.
I/O - HW Identification read only Use this parameter to view the hardware ID number of the
I/O module.
I/O - SW Rev.Number read only Use this function to view the software revision number of the
I/O module.
I/O - SW Identification read only Use this parameter to view the software ID number of the
I/O module.
I/O - Prod.Number read only Use this function to view the production number of the I/O module.
Device Software read only Use this function to view the device software version.