Endress+Hauser Proline Promass 83 - Display Transducer Block parameters

3 Transducer Block Device Functions Proline Promass 83 FOUNDATION Fieldbus
134 Endress+Hauser
3.5 "Display" Transducer Block parameters
The following table shows the Endress+Hauser-specific parameters of the "Display" Transducer
Block. These can only be changed after entering a release code in the "Access - Code" parameter.
!
Note!
FOUNDATION Fieldbus parameters are described in the Operating Instructions "FOUNDATION
Fieldbus Overview" (BA013S) (available at: → www.endress.com → download).
"Display" Transducer Block/base index 1800
Parameter
Write access
with operating
mode
(MODE_BLK)
Description
Access - Code AUTO - OOS All data of the measuring system are protected against inadvertent change.
Only when the code has been entered in this parameter can the
manufacturer-specific parameters be programmed and the device
configuration modified.
You can enable programming by entering:
• Code 83 (factory setting)
•Personal code ( → Page 135)
User input:
Max. 4-digit number (0 to 9999)
! Note!
• If the write protection is enabled then access to the manufacturer-specific
parameters is blocked even if the right code is entered. Write protection
can be activated and deactivated by means of jumpers on the I/O board
(→ See Operating Instructions for Proline Promass 83 FOUNDATION
Fieldbus).
• You can disable programming again by entering any number (other than
the release code) in this parameter.
• The Endress+Hauser service organization can be of assistance if you
mislay your personal code.
• Certain parameters are not accessible unless a special
service code is entered. This service code is known only to the
Endress+Hauser service organization. Please contact your
Endress+Hauser service center if you require clarification.
• The entry made here does not affect the local display. Programming via
the function matrix thus has to be enabled separately.
Access - Status read only Use this parameter to display the current status of the possibilities for
accessing the manufacturer-specific parameters of the device.
Display:
• LOCKED (parameterization disabled)
• ACCESS CUSTOMER (parameterization enabled)
• ACCESS SERVICE (parameterization enabled, access to service level)
Access - Code
Counter
read only Displays how often the customer code, service code or the digit "0"
(code-free) has been entered to gain access to the measuring device.
Display:
Max. 7-digit number: 0 to 9999999
Factory setting:
0