Endress+Hauser Proline Promass 83 - Function Group DENSITY COEFFICIENT

Device Functions Proline Promass 83 FOUNDATION Fieldbus 7 Block BASIC FUNCTION
Endress+Hauser 63
7.4.3 Function group DENSITY COEFFICIENT
BASIC FUNCTION G
⇒
FOUNDATION FIELDBUS GGA
⇓
PROCESS PARAMETER GIA
⇓
SYSTEM PARAMETER GLA
⇓
SENSOR DATA GNA
⇒
CONFIGURATION 680
⇓
FLOW COEF. 684
⇓
DENSITY COEFFICIENT 685
Function description
BASIC FUNCTION → SENSOR DATA → DENSITY COEFFICIENT
All density coefficients are set at the factory. All the sensor's parameter settings are saved on the S-DAT memory chip.
Contact the Endress+Hauser service organization if you have any questions about these functions.
DENSITY COEFFICIENT
C0
(6850)
This function shows the actual density coefficient C0.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C1
(6851)
This function shows the actual density coefficient C1.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C2
(6852)
This function shows the actual density coefficient C2.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C3
(6853)
This function shows the actual density coefficient C3.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C4
(6854)
This function shows the actual density coefficient C4.
" Caution!
A density adjustment can alter the calibration value of this coefficient.
DENSITY COEFFICIENT
C5
(6855)
This function shows the actual density coefficient C5.
" Caution!
A density adjustment can alter the calibration value of this coefficient.