Endress+Hauser Proline Promass 83 - Function Group ACQUISITION

Device Functions Proline Promass 83 FOUNDATION Fieldbus 8 Block SPECIAL FUNCTION
Endress+Hauser 73
8.2.2 Function group ACQUISITION
SPECIAL FUNCTION H
⇒
DENSITY FUNCTIONS HAA
⇓
ADVANCED DIAGNOSTICS HEA
⇒
CONFIGURATION 740
⇓
ACQUISITION 741
Function description
SPECIAL FUNCTION → ADVANCED DIAGNOSTICS → ACQUISITION
ACQUISITION MODE
(7410)
Use this function to specify whether the advanced diagnostics parameters should be
determined on a periodical or single-shot basis.
Options:
OFF
PERIODICAL
SINGLE SHOT
Factory setting:
OFF
! Note!
See the Chapter on "Commissioning" in the Operating Instructions Proline Promass 83,
BA065D/06/en for more information on advanced diagnostics.
ACQUISITION PERIOD
(7411)
! Note!
This function is not available unless PERIODICAL was selected in the ACQUISITION
MODE function (7410).
Use this function to specify the time interval after which the advanced diagnostics
parameters should be recorded. The time interval starts with the confirmation of the
input.
User input:
0 to 99999 s
Factory setting:
3600 s
! Note!
A reference status must be defined prior to determining the diagnosis parameters,
(→ SELECT REFERENCE CONDITION function (7402)).
DO ACQUISITION
(7412)
! Note!
This function is not available unless SINGLE SHOT was selected in the ACQUISITION
MODE function (7410).
Use this function to start determining the advanced diagnostics parameters on a
single–shot basis.
Options:
CANCEL
START
Factory setting:
CANCEL
! Note!
A reference status must be defined prior to determining the diagnosis parameters,
(→ SELECT REFERENCE CONDITION function (7402)).
RESET HISTORY
(7413)
Use this function to delete all history values.
Options:
NO
YES
Factory setting:
NO