Device Functions Proline Promass 83 FOUNDATION Fieldbus 5 Block USER INTERFACE
Endress+Hauser 41
ASSIGN
(2620)
(Continued)
Advanced options with optional software package CONCENTRATION:
TARGET MASS FLOW
% TARGET MASS FLOW
TARGET VOLUME FLOW
% TARGET VOLUME FLOW
CORRECTED TARGET VOLUME FLOW
CARRIER MASS FLOW
% CARRIER MASS FLOW
CARRIER VOLUME FLOW
% CARRIER VOLUME FLOW
CORRECTED CARRIER VOLUME FLOW
% BLACK LIQUOR
° BAUME
° API
° PLATO
° BALLING
° BRIX
Advanced options with optional software package ADVANCED DIAGNOSTICS:
MASS FLOW DEVIATION
DENSITY DEVIATION
REFERENCE DENSITY DEVIATION
TEMPERATURE DEVIATION
TUBE DAMPING DEVIATION
ELECTRODYNAMIC SENSOR DEVIATION
OPERATING FREQUENCY FLUCTUATION DEVIATION
TUBE DAMPING FLUCTUATION DEVIATION
! Note!
Multiplex mode is suspended as soon as a fault/notice message is generated.
The message in question appears on the display.
• Fault message (identified by a lightning icon):
Multiplex mode is resumed as soon as the fault is no longer active.
• Notice message (identified by an exclamation mark):
Multiplex mode is resumed as soon as the notice message is no longer active.
100%-VALUE
(2621)
! Note!
This function is not available unless one of the following was selected in the ASSIGN
function (2620):
• MASS FLOW IN %
• VOLUME FLOW IN %
• CORRECTED VOLUME FLOW IN %
• MASS FLOW BAR GRAPH IN %
• VOLUME FLOW BAR GRAPH IN %
• CORRECTED VOLUME FLOW BAR GRAPH IN %
Use this function to define the flow value to be shown on the display as the
100% value.
User input:
5-digit floating-point number
Factory setting:
Depends on nominal diameter and country → Page 90 ff.
Function description
USER INTERFACE → INFORMATION LINE → MULTIPLEX
To Next Page
Loading...
