Endress+Hauser Proline Promass 83 - Flow Transducer Block parameters

Device Functions Proline Promass 83 FOUNDATION Fieldbus 3 Transducer Block
Endress+Hauser 113
3.2.4 Diagnosis
The status of the device is displayed via the following parameters specified in the FOUNDATION
Fieldbus specification:
• BLOCK_ERR
• Transducer Error
Detailed information on the current device status is displayed via the "Diagnosis" Transducer Block
in the manufacturer-specific parameter "Diag. - Act.Sys.Condition" ( → Page 131).
For more information on rectifying errors → See Operating Instructions for Proline Promass 83
FOUNDATION Fieldbus (BA065D), "Troubleshooting" section.
3.2.5 Accessing the device-specific parameters
To access the device-specific parameters the following requirements must be met:
1. Hardware write protection must be deactivated → See Operating Instructions for Proline
Promass 83 FOUNDATION Fieldbus (BA065D).
2. The correct code must be entered in the parameter
"Access - Code" via the corresponding Transducer Block.
3.3 "Flow" Transducer Block parameters
The following table shows the Endress+Hauser-specific parameters of the "Flow" Transducer Block.
These can only be changed after entering a release code in the "Access - Code" parameter.
!
Note!
FOUNDATION Fieldbus parameters are described in the Operating Instructions "FOUNDATION
Fieldbus Overview" (BA013S) (available at: → www.endress.com → download).