Device Functions Proline Promass 83 FOUNDATION Fieldbus 3 Block MEASURED VARIABLES
Endress+Hauser 17
3.2.2 Function group ADDITIONAL CONFIGURATION
MEASURED
VARIABLES
A
⇒
MEASURING VALUES AAA
⇓
SYSTEM UNITS ACA
⇒
CONFIGURATION 040
⇓
ADD. CONFIGURATION 042
Function description
MEASURED VARIABLES → SYSTEM UNITS → ADDITIONAL CONFIGURATION
! Note!
The units selected here have no effect on the fieldbus. They are only used for the local display and for assigned
instrument functions.
UNIT DENSITY
(0420)
Use this function to select the unit for displaying the fluid density.
The unit you select here is also valid for:
• Switching points (limit value for density)
• Density response value for EPD
• Density adjustment value
Options:
Metric → g/cm
3
; g/cc; kg/dm
3
; kg/l; kg/m
3
; SD 4 °C, SD 15 °C, SD 20 °C;
SG 4 °C, SG 15 °C, SG 20 °C
US → lb/ft
3
; lb/gal; lb/bbl (normal fluids); lb/bbl (beer);
lb/bbl (petrochemicals); lb/bbl (filling tanks)
Imperial → lb/gal; lb/bbl (beer); lb/bbl (petrochemicals)
Factory setting:
kg/l
SD = Specific Density, SG = Specific Gravity
The specific density is the ratio of fluid density to water density (at water temperature =
4, 15, 20 °C).
UNIT REFERENCE
DENSITY
(0421)
Use this function to select the unit for displaying the reference density.
The unit you select here is also valid for:
• Switching points (limit value for density)
• Fixed reference density (for calculation of corrected volume flow)
Options:
Metric → kg/Nm
3
; kg/Nl
US → g/Scc; kg/Sm
3
; lb/Scf
Factory setting:
kg/Nl
UNIT TEMPERATURE
(0422)
Use this function to select the unit for displaying the temperature.
The unit you select here is also valid for:
• Switching points (limit value for temperature)
• Reference temperature (for corrected volume measurement with
measured reference density)
Options:
°C (Celsius)
K (Kelvin)
°F (Fahrenheit)
R (Rankine)
Factory setting:
°C
To Next Page
Loading...
