Endress+Hauser Proline Promass 83 - Function Group ADDITIONAL COEFFICIENT

7 Block BASIC FUNCTION Device Functions Proline Promass 83 FOUNDATION Fieldbus
64 Endress+Hauser
7.4.4 Function group ADDITIONAL COEFFICIENT
BASIC FUNCTION G
⇒
FOUNDATION FIELDBUS GGA
⇓
PROCESS PARAMETER GIA
⇓
SYSTEM PARAMETER GLA
⇓
SENSOR DATA GNA
⇒
CONFIGURATION 680
⇓
FLOW COEF. 684
⇓
DENSITY COEFFICIENT 685
⇓
ADDITIONAL
COEFFICIENT
686
Function description
BASIC FUNCTION → SENSOR DATA → ADDITIONAL COEFFICIENT
All sensor data are set at the factory. All the sensor's parameter settings are saved on the S-DAT memory chip.
" Caution!
These functions are used for displaying device parameters only and consequently cannot be accessed.
Contact the Endress+Hauser service organization if you have any questions about these functions.
MINIMAL
TEMPERATURE
MEASURED
(6860)
The lowest fluid temperature measured appears on the display.
MAXIMAL
TEMPERATURE
MEASURED
(6861)
The highest fluid temperature measured appears on the display.
MINIMAL
TEMPERATURE
CARRIER TUBE
(6862)
The lowest carrier tube temperature measured appears on the display.
! Note!
This function is not available for the Promass E measuring device.
MAXIMUM
TEMPERATURE
CARRIER TUBE
(6863)
The highest carrier tube temperature measured appears on the display.
! Note!
This function is not available for the Promass E measuring device.