Endress+Hauser Proline Promass 83 - Page 135

Device Functions Proline Promass 83 FOUNDATION Fieldbus 3 Transducer Block
Endress+Hauser 135
Access -
Def.Private Code
AUTO - OOS Use this function to enter a personal code to enable configuration. This
applies both to manufacturer-specific parameters in the Transducer Blocks
and to operating via the local display.
User input:
0 to 9999 (max. 4-digit number)
Factory setting:
83
! Note!
• If the code number is "0", programming is always enabled.
• Parameter configuration has to be enabled before this code can be
changed.
Config. - Language AUTO - OOS Use this parameter to select the language for all texts, parameters and
messages shown on the local display.
! Note!
The displayed options depend on the language group available which is
shown in the "Amp. - Language Group" parameter.
Options:
Language group WEST EU / USA:
ENGLISH
DEUTSCH
FRANCAIS
ESPANOL
ITALIANO
NEDERLANDS
PORTUGUESE
Language group EAST EU / SCAND:
ENGLISH
NORSK
SVENSKA
SUOMI
POLISH
RUSSIAN
CZECH
Language group ASIA:
ENGLISH
BAHASA INDONESIA
JAPANESE (syllabary)
Language group CHINA:
ENGLISH
CHINESE
Factory setting:
Depends on country → Page 193 ff.
! Note!
You can change the language group via the configuration software
ToF Tool-Fieldtool Package. Please do not hesitate to contact your
Endress+Hauser sales office if you have any questions.
"Display" Transducer Block/base index 1800
Parameter
Write access
with operating
mode
(MODE_BLK)
Description