Device Functions Proline Promass 83 FOUNDATION Fieldbus 3 Transducer Block
Endress+Hauser 133
Sys. -
T-DAT Save/Load
AUTO - OOS Use this parameter to save the parameter settings / configuration of the
transmitter in a transmitter DAT (T-DAT), or to load the parameter settings
from the T-DAT into the EEPROM (manual backup function).
Application examples:
• After commissioning, the current measuring point parameters can be
saved to the T-DAT as a backup.
• If the transmitter is replaced for some reason, the data from the T-DAT
can be loaded into the new transmitter (EEPROM).
Options:
CANCEL
SAVE (from EEPROM to T-DAT)
LOAD (from the T-DAT into EEPROM)
Factory setting:
CANCEL
! Note!
• If the target device has an older software version, the message
"TRANSM. SW–DAT" is displayed during startup. Then only the SAVE
option is available.
•LOAD
This option is only possible:
– If the target device has the same software version as, or a more recent
software version than, the source device or
– If the T-DAT contains valid data that can be called up.
• SAVE This option is always available.
Amp. Device Type read only This parameter is only used for service purposes.
"Diagnosis" Transducer Block/base index 1600
Parameter
Write access
with operating
mode
(MODE_BLK)
Description
To Next Page
Loading...
