Device Functions Proline Promass 83 FOUNDATION Fieldbus 3 Transducer Block
Endress+Hauser 165
Dens. - A3 read only Coefficient A3 entry.
User input:
5-digit floating-point number
Factory setting:
0
Dens. - A4 read only Coefficient A4 entry.
User input:
5-digit floating-point number
Factory setting:
0
Dens. - B1 read only
! Note!
The option is not active unless the % MASS 3D or % VOLUME 3D option
was selected in the parameter "Dens. - Mode" ( → Page 163).
Coefficient B1 entry.
User input:
5-digit floating-point number
Factory setting:
0
Dens. - B2 read only
! Note!
The option is not active unless the % MASS 3D or % VOLUME 3D option
was selected in the parameter "Dens. - Mode" ( → Page 163).
Coefficient B2 entry.
User input:
5-digit floating-point number
Factory setting:
0
Dens. - B3 read only
! Note!
The option is not active unless the % MASS 3D or % VOLUME 3D option
was selected in the parameter "Dens. - Mode" ( → Page 163).
Coefficient B3 entry.
User input:
5-digit floating-point number
Factory setting:
0
Amp. Device Type read only This parameter is only used for service purposes.
"Calculated Density" Transducer Block/base index 2000
Parameter
Write access
with operating
mode
(MODE_BLK)
Description
To Next Page
Loading...
