Device Functions Proline Promass 83 FOUNDATION Fieldbus 5 Block USER INTERFACE
Endress+Hauser 33
FORMAT
(2402)
! Note!
This function is not available unless a number was selected in the ASSIGN function
(2400).
Use this function to define the maximum number of places after the decimal point
displayed for the reading in the additional line.
Options:
XXXXX. - XXXX.X - XXX.XX - XX.XXX -X.XXXX
Factory setting:
X.XXXX
! Note!
• Note that this setting only affects the reading as it appears on the display, it has no
influence on the accuracy of the system's calculations.
• The places after the decimal point as computed by the measuring device cannot
always be displayed, depending on this setting and the engineering unit. In these
instances an arrow appears on the display between the measured value and the
engineering unit (e.g. 1.2 → kg/h), indicating that the measuring system is
computing with more decimal places than can be shown on the display.
DISPLAY MODE
(2403)
! Note!
This function is not available unless one of the following was selected in the ASSIGN
function (2400):
• MASS FLOW BAR GRAPH IN %
• VOLUME FLOW BAR GRAPH IN %
• CORRECTED VOLUME FLOW BAR GRAPH IN %
Use this function to define the format of the bar graph.
Options:
STANDARD
Simple bar graph with 25 / 50 / 75% gradations and integrated sign.
A0001258
SYMMETRY
Symmetrical bar graph for positive and negative directions of flow, with
–50 / 0 / +50% gradations and integrated sign.
A0001259
Factory setting:
STANDARD
Function description
USER INTERFACE → ADDITION LINE → CONFIGURATION
To Next Page
Loading...
