Epson Stylus Photo R1800 - Removing the Belt Holder; Removing the CR Encoder Board Holder; Removing the Sensor FFC

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 101
23. Turn the Belt Holder Mounting Plate in the direction of the arrow, and
remove it from the Carriage Unit.
Figure 4-71. Removing the Belt Holder (1)
24. Remove the Belt Holder from the Carriage unit.
Figure 4-72. Removing the Belt Holder (2)
25. Release the CR Encoder Board Holder from the three Tabs to remove it
from the Carriage Unit.
Figure 4-73. Removing the CR Encoder Board Holder
26. Disconnect the Sensor FFC from the Connector on the CSIC Board.
Figure 4-74. Removing the Sensor FFC
Belt Holder Mounting Plate
Belt Holder
CR Encoder Board Holder
Tabs
Sensor FFC