Epson Stylus Photo R1800 - Required Adjustment Tools

EPSON Stylus Photo R1800/R2400 Revision B
Adjustment Adjustment Items and Overview 136
5.1.3 Required Adjustment Tools
The following table lists the adjustment tools required for adjustment of this
product.
Note : For tools required for the Colorimetric Calibration, See Section 5.2.4 on page
147.
Table 5-5. List of Tools
No. Name Part Code Category Overview
1
Adjustment
Program
–
Software
This adjustment program is
designed to display the
required adjustment items in
the appropriate order when a
replacement part is selected,
and provides workers with
the accurate adjustment
order.
2
G-26
1080614 Grease
For the Parallelism Adjust
Bushing, Lower Paper
Guide, Driven Release Shaft,
etc.
3
G-45
1033657 Grease
For the PF Roller, Front
Paper Guide, Rear Paper
Guide and etc.
4
G-71
1304682 Grease
For the Carriage Unit and
Carriage Shaft.
5
PG Adjustment
Gauge
1276333 Gauge
A gauge exclusively used to
make PG Adjustment. Check
the corrction value by
energizing it in the same way
as for Stylus Photo R800.
6
PF Tension
Measuring Tool
1231678 Measuring
tool
Used to check whether or not
the tension of the PF Drive
Belt is within the specified
value. If load is greater than
the specified value, the PF
Motor may generate heat,
burning off the coil.
Reversely, if load is less than
the specified value, the paper
feed position may shift.
7
PF Roller Shaft
Position
Adjustment Jig
1304993 Adjusting
jig
Used to check whether or not
the deflection amount of the
PF Roller Shaft is within the
specified value. Adjustment
values are confirmed in a
pair with the level block.
8
Level
1304994 Adjusting
jig
Used to check whether or not
deflection amount of the PF
Roller Shaft is within the
specified value. Adjustment
values are confirmed in a
pair with the PF Roller Shaft
Position Adjustment Jig.
Table 5-5. List of Tools
No. Name Part Code Category Overview