Epson Stylus Photo R1800 - Paper Problems

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 98
14. Loosen the C.B.S. (P4) M3 x 8 screw that secures the Left Parallelism
Adjust Bushing, and rotate the Bushing toward the front of the Printer
Mechanism to prevent interference between the Flag of the Parallelism
Adjust Bushing and the Left PG Cam.
Figure 4-59. Rotating the Left Parallelism Adjust Bushing
15. Slide the Left CR Shaft Mounting Plate upwards, and release the Tab on
the Left CR Shaft Mounting Plate from the notch on the Main Frame to
rotate the Mounting Plate toward you.
Figure 4-60. Rotating the Left CR Shaft Mounting Plate
16. Lift the Carriage Shaft upwards, and remove the Carriage Shaft Spacer
from the Carriage Shaft with tweezers.
Figure 4-61. Removing the Carriage Shaft Spacer
17. Rotate the Left CR Shaft Mounting Plate toward you to remove the
Bushing on the Left CR Shaft Mounting Plate from the Carriage Shaft.
Figure 4-62. Removing the Left CR Shaft Mounting Plate
6) C.B.S. (P4) 3x8
(5±1 kgf.cm)
Left PG Cam
Flag of the Parallelism Adjust Bushing (Left)
Left CR Shaft
Mounting Plate
Tab
Carriage
Shaft
Carriage Shaft Spacer
Left CR Shaft
Mounting Plate
Bushing