Epson Stylus Photo R1800 - Lubrication of Carriage Shaft

EPSON Stylus Photo R1800/R2400 Revision B
Maintenance Overview 178
Figure 6-13. Lubrication (12)
6.1.4.1 Lubrication of Carriage Shaft
1. Fit the Carriage Unit onto the Carriage Shaft, and move it to the center of
the Shaft.
2. Using a syringe, lubricate the holes (2 places) at both ends of the Carriage
Unit rear side with grease.
Figure 6-14. Lubricating the Carriage Shaft (1)
<Lubrication Point>
1. Contact point of the Rear
Paper Guide and the PF Roller
2. Contact point of the PF
Grounding Spring and the PF
Roller
<Lubrication Type>
G-45
<Lubrication Amount>
1. Apply evenly.
2. φ1mm x 2mm
<Remarks>
1. Apply with a brush.
2. Apply with a syringe.
(Pin Head:
φ1mm)
1
1
2
PF Roller
Rear Paper GuidePF Grounding Spring
C A U T I O N
In the following step, do not bring the needle of a syringe
into contact with the Carriage Shaft.
Lubrication Type Lubrication Amount
G-71 280mg x 2 points
Carriage Unit
Carriage Shaft
Holes