Epson Stylus Photo R1800 - Removing the PF Motor; Reinstalling the PF Motor

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 123
4.2.7.2 PF Motor
1. Remove the Printer Mechanism. See Section 4.2.1.5 on page 78.
2. Disconnect the PF Motor Connector Cable from Connector CN16 (black)
on the Main Board, and remove it from the Clamp on the Main Frame.
3. Remove the two C.C. M3 x 4 screws that secure the PF Motor.
4. Remove the PF Drive Belt from the PF Motor Pinion Gear, and remove the
PF Motor from the Printer Mechanism.
Figure 4-133. Removing the PF Motor
PF Motor
1
2
PF Drive Belt
11) C.C. 3x4
(4±0.5 kgf.cm)
PF Motor Connector Cable
Clamp
CN16
Pinion Gear
 Make the slit on the PF Motor face the direction shown in
the figure below.
Figure 4-134. Reinstalling the PF Motor
 Tighten the screws in the order shown in Figure 4-133.
A D J U S T M E N T
R E Q U I R E D
After replacing or removing the PF Motor, be sure to make the
following adjustments.
1. PF Belt Tension Adjustment
2. PF Roller Shaft Center Support Position Adjustment
3. PF Adjustment
4. PF Adjustment (Bottom Margin)
Refer to Chapter 5 "Adjustment" for details of the
adjustments.
Slit