Epson Stylus Photo R1800 - Aligning the Print Head

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 84
9. Remove the two C.B.S. M3 x 6 screws that secure the two Guide Roller
LDs.
10. Gently pull the LD Roller Shaft to the rear of the printer, and remove the
Guide Roller LDs.
Figure 4-22. Removing the Guide Roller LD
11. Remove the three C.B.S. (P4) M3 x 8 screws that secure the ASF Assy,
and remove the ASF Assy from the Printer Mechanism.
Figure 4-23. Removing the ASF Assy
Referring to Figure 4-21., correctly route each of the Cables
and FFC.
Align the Guide Pins and Tabs on the Guide Roller LDs with
the positioning holes on the Main Frame. Refer to Figure
4-22.
Front
Face
2) C.B.S. 3x6
(8±1 kgf.cm)
Guide Pin
Tab
LD Roller Shaft
Guide Roller LD
Guide Roller LD
2
1
6) C.B.S. (P4) 3x8
(6±1 kgf.cm)
ASF Assy
6) C.B.S. (P4) 3x8
(6±1 kgf.cm)
3