Epson Stylus Photo R1800 - Upper Paper Guide Assys; Attaching the Perforated Sheets and the LD Cover Sheet; Setting the Paper

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 114
4.2.6.11 Upper Paper Guide Assys.
1. Remove the FLAG Release Assy. See Section 4.2.6.10 on page 113.
2. Remove the PE Sensor Holder. See Section 4.2.8.1 on page 124.
3. Pass a sheet of A3 size paper into the gap between the Upper Paper
Guide Assy and the Rear Paper Guide.
Figure 4-110. Setting the Paper
Attach the five Perforated Sheets and the LD Cover Sheet to
the six locations shown in the figure below to prevent ink
from sticking to the LD Rollers.
 Remove the five Paper Guide Torsion Springs from the
Tabs, insert the notches of the Perforated Sheets into
the Tabs to attach them to the Main Frame, and then
hook the Paper Guide Torsion Springs onto the Tabs
again.
 Insert the LD Cover Sheet in between the frame so that
the Tabs on the upper side of the LD Cover Sheet are
visible from the notches on the Main Frame, and attach
the LD Cover Sheet.
Figure 4-109. Attaching the Perforated Sheets and the LD
Cover Sheet
LD Cover Sheet Perforated Sheets
Paper Guide Torsion Spring
Tab
Tab
A3-size paper
Rear Paper Guide