EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 118
Align the Bushing of the Front Paper Guide with the PF
Roller Shaft.
Figure 4-119. The PF Roller Shaft and the Bushing of the
Front Paper Guide
Align the positioning holes on the Main Frame with the
Guide Pins on the Front Paper Guide.
Figure 4-120. Reinstalling the Front Paper Guide
Shaft and Bushing
Guide Pins
After installing the Front Paper Guide, lift the Printer
Mechanism to check the following points.
1. Make sure that the Tabs on the Paper Guide Pad are not
cut midway.
2. Make sure that all Tabs are facing down (toward the
Waste Ink Pads) without any folds.
3. Make sure that the Tab foldbacks are protruding
completely from the Front Paper Guide.
Figure 4-121. Checking the Front Paper Guide Pad
A D J U S T M E N T
R E Q U I R E D
After replacing the following part, be sure to apply G-45 grease
to the area specified for each part.
EJ Grounding Spring See Figure 6-10 on page 177.
Front Paper Guide and Paper Eject Roller See Figure 6-11
on page 177.
A D J U S T M E N T
R E Q U I R E D
Be sure to perform the following adjustments after the Front
Paper Guide and Paper eject roller are replaced or removed:
1. Ink Mark Sensor Adjustment
2. PW Sensor Adjustment
3. PF Adjustment
4. PF Adjustment (Bottom Margin)
Refer to Capter 5 "Adjustment" for details of the
adjustments.
Tabs
Tabs
To Next Page
Loading...
