Epson Stylus Photo R1800 - Upper Housing; Interference between the Frame and Carriage Unit; Screws that Secure the Upper Housing

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 76
4.2.1.4 Upper Housing
1. Remove the Side Housing. See Section 4.2.1.2 on page 74.
2. Open the Printer Cover and Paper Support.
3. Open the CD-R Unit. See Section 4.2.1.3 on page 75.
4. Remove the six C.B.P. M3 x 10 screws and three C.B.S. M3 x 6 screws
that secure the Upper Housing.
Figure 4-7. Screws that Secure the Upper Housing
C A U T I O N
When moving the Carriage Unit with the CD-R Unit opened,
turn the PG CAM (Right) beforehand so that PG++ points
downwards to release the PG in order to prevent interference
between the Paper EJ Frame and Carriage Unit.
Figure 4-6. Interference between the Frame and Carriage Unit
PG Cam (Right)
Point of
Interference
Paper EJ Frame
PG++ position
Carriage
Unit
Paper
Support
1
Guide Pin
3
Guide Pin
5
4
9
Tab
2
6
Tab
7
8
1) C.B.P. 3x10
(6±1 kgf.cm)
2) C.B.S. 3x6
(6±1 kgf.cm)
CD-RUnit
Upper
Housing
Printer Cover