Epson Stylus Photo R1800 - Maintaining Your Printer; Cleaning the Print Head

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 77
5. Disconnect the Panel FFC and CD-R Sensor Cable from connectors CN1
and CN2 on the Switch Board, and release the CD-R Sensor Cable from
the tabs of the Upper Housing.
Figure 4-8. Disconnecting the CD-R Sensor Cable and Panel FFC
6. Remove the Guide Pins from the two Tabs shown in Figure 4-7., and
remove the Upper Housing upwards.
PRINTER COVER
7. Remove the two C.B.P. M3 x 10 screws that secure the Left Printer Cover
Holder, and draw it out in the direction of the arrows.
Remove the Right Printer Cover Holder in the same way.
Figure 4-9. Disconnecting the Printer Cover Holder
 Align the Guide Pins with the positioning holes on the
Upper Housing. See Figure 4-7.
 When inserting the CD-R Sensor Cable into the Switch
Board, press the Connector CN2 to make sure that it is
firmly installed on the Switch Board.
 Referring to Figure 4-7., correctly route the Panel FFC
and CD-R Sensor Cable.
 Tighten the screws in the order shown in Figure 4-7.
Tabs
CN2
CN1
Panel FFC
Guide Pin
CD-R Sensor Cable
1) C.B.P. 3x10
(6±1 kgf.cm)
Right Printer Cover Holder
Left Printer Cover Holder