Epson Stylus Photo R1800 - Epson America, Inc. Limited Warranty

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 109
4.2.6.8 Ink System Unit
1. Remove the Right CD-R Release Lever SubAssy. See Section 4.2.6.7 on
page 106.
2. Release the Carriage lock, and move the Carriage Unit to the center. See
Section 4.2.1.3 on page 75.
3. Remove the C.B.S. M3 x 8 screw that secures the Earth Cable to remove
the Earth Cables, and untie the Earth Cable from the Relay Connector
Cable.
4. Disconnect the Pump Motor Connector from the Relay Connector.
Figure 4-95. Disconnecting the Pump Motor Connector
5. Remove the two C.B.S. M3 x 4 screws that secure the Ink System Guide
Plate, and remove it.
Figure 4-96. Removing the Ink System Guide Plate
 Be sure to screw the two Earth Cables together.
 Referring to Figure 4-95., correctly route the Relay
Connector Cable.
Relay Connector
5) C.B.S. 3x8
(8±1 kgf.cm)
Earth Cable
Relay Connector Cable
 Align the notch on the Ink System Guide Plate with the
notch on the Main Frame.
Figure 4-97. Reinstalling the Ink System Guide Plate
 Tighten the screws in the order shown in Figure 4-96.
1
2
10) C.B.S. 3x4
(8±1 kgf.cm)
Ink System
Guide Plate