Epson Stylus Photo R1800 - Removing the Extension Spring for the Driven Pulley Holder; Removing the Driven Pulley Holder; Removing the CR Drive Belt; Removing the CR Guide Plate

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 97
10. Remove the Extension Spring for the Driven Pulley Holder from the Main
Frame and the Tab on the Drive Pulley Holder with needle-nose pliers.
Figure 4-55. Removing the Extension Spring for the Driven Pulley Holder
11. Remove the Driven Pulley Holder toward you after sliding it to the right end
of the notch on the Main Frame.
Figure 4-56. Removing the Driven Pulley Holder
12. Remove the CR Drive Belt from the CR Motor Pinion Gear.
Figure 4-57. Removing the CR Drive Belt
13. Remove the four C.B.S. (P4) M3 x 6 screws that secure the CR Guide
Plate, and remove it from the Main Frame.
Figure 4-58. Removing the CR Guide Plate
Tabs
Extension Spring for the
Driven Pulley Holder
Driven Pulley Holder
Driven Pulley
Driven Pulley Holder
 Align the positioning holes on the CR Guide Plate with
the seven Tabs on the Main Frame. See Figure 4-58.
 Tighten the screws in the order shown in Figure 4-58.
CR Drive Belt
CR Motor Pinion Gear
CR Guide Plate
4
3
2
1
8) C.B.S. (P4) 3x6
(8±1 kgf.cm)
8) C.B.S. (P4) 3x6
(8±1 kgf.cm)
Tabs