Epson Stylus Photo R1800 - FLAG Release Assy; Parallel Pin 1.5; Removing the FLAG Release Assy

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 113
4.2.6.10 FLAG Release Assy.
1. Remove the APG Assy. See Section 4.2.6.3 on page 93.
2. Remove the Release Holder Assy. See Section 4.2.6.9 on page 112.
3. Remove the Guide Pin on the Driven Release Holder from the Main Frame
using tweezers, and slide the Driven Release Holder to the left as viewed
from the front of the Printer Mechanism.
4. Release the three Tabs on the Driven Release Holder from the Main
Frame, and remove the FLAG Release Assy.
Figure 4-108. Removing the FLAG Release Assy
C A U T I O N
In the following procedure, Parallel Pin 1.5 may drop off
when the Driven Release Holder is slid. Be careful not to
lose it.
Figure 4-107. Parallel Pin 1.5
Parallel Pin 1.5
Guide Pin
Tabs
Front
Driven Release Holder
Rear
Guide pin
Tabs
Tab
Front
FLAG Release Assy.