Epson Stylus Photo R1800 - Center Support Bushing Cam and the Screw

EPSON Stylus Photo R1800/R2400 Revision B
Adjustment Adjustment 144
4. Loosen the screws that secure the Center Support Bushing Cam and the
Center Support Bush.
Figure 5-14. Center Support Bushing Cam and the Screw
5. Set the jig in place on the PF Roller Shaft as shown in the figure below.
 Left side: Inside of PF Roller left end (E-ring)
 Right side: Clearance between PF Roller right end (Right Bushing 8)
and left end of Upper Paper Guide
 Center: Clearance between the 2nd Upper Paper Guide and 3rd one
from the left
Figure 5-15. Setting the PF Roller Shaft Position Adjustment Jig (2)
Center Support
Bushing Cam
Bottom of Rear Center
C A U T I O N
Check for any dirt on the PF Roller Shaft when performing
the following procedure.