Epson Stylus Photo R1800 - Removing the Print Head; Removing the Head FFC; Attaching the Pad; Reinstalling the Print Head

EPSON Stylus Photo R1800/R2400 Revision B
Disassembly And Assembly Disassembly 90
5. Remove the three C.B.P. M2.6 x 8 screws that secure the Print Head using
No.1 Phillips Screw Driver, and vertically lift the Print Head to remove.
Figure 4-33. Removing the Print Head
6. Remove the two Head FFCs from the Print Head.
Figure 4-34. Removing the Head FFC
Head
7) C.B.P. 2.6x8
(3±0.5 kgf.cm)
1
2
3
Head FFC
 Make sure that the Pad is attached at the position in
Figure 4-35..
Figure 4-35. Attaching the Pad
 The Print Head must be installed with the Guide Pins of
the Carriage Unit aligned with the positioning holes on
the Print Head.
Figure 4-36. Reinstalling the Print Head (1)
Pad
Guide Pins
Positioning Holes